Main unit
1
Thread take-up bracket assembly
*Key point
• Make 6 thread take-up bracket assemblies.
1. Attach the spring
to the thread catching spring case 1.
S49
*Key point
• There are 4 holes on the spring case. Insert the tip of the
S49
spring
into the hole indicated by the arrow in the figure.
2. Attach the thread catching spring case assembly to the thread take-up
bracket with the screw 1.
*Key point
• Align the protrusion on the thread catching spring case
assembly with the hole on the thread take-up bracket, and turn
them counterclockwise until they stop. Then tighten the screw
1.
3. Attach the thread guide wire 2 and the thread guard 3 to the thread take-
up bracket with the screw 2.
*Key point
• Check that the spring
Start movie clip (CD-ROM version only)
1
2
S49
8.5
Thread tension unit
S49
does not extend beyond line A.
Screw, Pan (S/P washer)
0.59 – 0.78 N-m
M3X6DA
20.8
THREAD TAKE-UP SPRING
S49
Torque
XC5926***
(A)
1
1
3
2
2
3 - 11