Hoop Sensor Attachment - Brother PR600II Service Manual

Main unit
7

Hoop sensor attachment

1. Attach the spring to the X-carriage A assembly.
S44
2. Attach the hoop sensor assembly 2 to the X-carriage A assembly with the
nut 1 and plain washer (S6), and then thread the hoop sensor assembly's
shaft through the spring
3. Attach the hoop lever to the hoop sensor shaft, hanging the spring
over the hoop lever 3, and then tighten the screw 1.
4. Tighten the screw 2 from the rear side of the X-carriage A assembly
(hoop sensor assembly side) while pushing down the hoop lever.
*Key point
• Tighten the screw with the hoop lever pushed down so that it
contacts the screw 2 from the beneath after the screw has
been tightened.
• Check operation after attachment.
Start movie clip (CD-ROM version only)
Tightening torque of nut:
1
2
4.5 3
S44
Feed unit
.
S44
Set Screw, Socket (FT)
M3X6 0.59 – 0.78 N-m
Screw, Bind
0.78 – 1.18 N-m
M3X12
5.4
6.4
1
3
S44
1
1.18 - 1.57 N-m
Torque
Torque
2
SPRING
XC5802***
2
2
S44
3 - 79