Brother PR600II Service Manual page 322

Wiring instructions
1. Left side of base
USB lead wire
Y-sensor lead wire
Cord clamp A
2.
Right side of base
Remove any slack in the Y-motor
lead wire to prevent it contacting the
Y-feed driving shaft, and then secure
the lead wire with the cord clamp.
Y-feed driving shaft
7 - 6
Base wiring
Cord clamp B
Make sure that the lead
wire is in the trench on
the base.
Inlet holder
Power lead wire
Y-feed driving gear
Hang the lead wire over the U-
shaped notch on the Y-sensor
PCB.
Y-feed driving belt
Y-sensor lead wire
USB lead wire B
Power PCB lead wire
Square hole
Round hole
Switch
holder
Power switch