NOTE
Every data of the Controller is stored to the Compact Flash inside the
Controller. When you execute the commands listed in the following page,
data is written to the Compact Flash. Frequent data writing to the Compact
Flash may shorten the Compact Flash life. It is recommended to use the
following commands only when it is necessary.
- Renew the Point files (SavePoints)
- Change the Robot parameters (Base, Local, LocalClr, CalPls, Calib,
Hofs, ArmSet, ArmClr, HomeSet, HomeClr, Hordr, MCOder, Weight,
JRange, Range, XYLim, TLSet, TLClr, Arm, Tool, Inertia, EcpSet, EcpClr,
Box, BoxClr, Plane, PlaneClr)
RC180 Safety and Installation Rev.18
ix