First Step; Installing Epson Rc+ 5.0 Software - Epson RC180 Safety And Installation

3. First Step

3. First Step
This section indicates the procedure to install the development PC EPSON RC+
5.0, and execute simple program after connecting the development PC and
Controller with a USB.
Make sure that the Robot system is installed safely by following the description in
1. Safety and 2. Installation. Then, operate the Robot system in the following
procedures.

3.1 Installing EPSON RC+ 5.0 Software

The EPSON RC+ 5.0 software needs to be installed on your development PC.
NOTE
EPSON RC+ 5.0 supports the following OS.
Windows XP Professional Service Pack 3
Windows Vista Business Service Pack 2
Windows 7 Professional
1. Insert the EPSON RC+ 5.0 Setup CD in the CD drive.
2. If EPSON RC+ 5.0 was previously installed, you will be asked to uninstall the
previous version, otherwise go to step 3.
After uninstalling, you will be prompted to restart the computer. Start the
setup program again by double-clicking the installer CD icon in My Computer,
or by re-inserting the CD.
72
(EPSON RC+ 5.0 Ver.5.2.0 SP3 or after is required.)
(EPSON RC+ 5.0 Ver.5.3.1 or after is required.)
(EPSON RC+ 5.0 Ver.5.3.4 or after is required.)
RC180 Safety and Installation Rev.18