Table of Contents
Advertisement
Network DISA Calling
To program an incoming code from an attendant phone:
In addition to the DISA ID Setting in FF1, the following procedure can be
used to program an incoming code.
1. Press the ON/OFF key.
2. Press the CONF key.
3. Dial "#7."
4. Enter the DISA code.
5. Press the HOLD key.
6. Press the ON/OFF key.
Hardware Requirements
• An MFR card is required for DISA. The MFR card is required to detect
Considerations
• Once an incoming DISA code is entered, you cannot blank it out without
• Busy override cannot be used for a DISA line.
Page 120
• The phone issues intercom dial tone.
• The ON/OFF LED lights.
The ON/OFF LED goes off.
DTMF tones entered via the DISA connection.
entering the programming mode.
T1 Networking - Revised April 2000
Network Feature Operation
DBS-2.3/9.2-540
Advertisement
Table of Contents
