Panasonic DBS Section 540 Reference Manual page 92

T1 Settings Added for Networking
Parameter
Description
Address
Options
Parameter
Description
Address
Options
Parameter
Description
Address
Options
Note
Page 92
Outpulse Delay Timer
Sets the time after receiving a wink before outpulsing
digits.
FF1 8# 4# 8# 3# (NWG)# 11# (0-8)#
0=1200 ms min
1=1200 ms min
2=1200 ms min
3=1200 ms min
4=1200 ms min
Wink Signal Wait Timer
Sets the time to wait for a wink to be received.
FF1 8# 4# 8# 3# (NWG)# 12# (0-15)#
0=150 ms
1=250 ms
2=500 ms
3=750 ms
4=1000 ms
5=1250 ms
6=1500 ms
7=1750 ms
Wink Signal Delay Answer Timer
Sets the time to wait before sending a wink.
FF1 8# 4# 8# 3# (NWG)# 13# (0-15)#
(See Note Below)
0=80 ms
1=90 ms
2=100 ms
3=120 ms
4=130 ms
5=140 ms
6=150 ms
7=160 ms
An incoming call detection and processing time must be
added to determine the actual time before a wink signal is
sent back. Typically this time is from 110-120 ms. For
instance, if the Wink Signal Delay Answer Timer is set to
100 ms, the actual wink will occur after approx. 210 ms.
T1 Networking-Revised April 2000
Programming
5=1400 ms
6=1700 ms
7=1900 ms
8=2200 ms
8=2000 ms
9=2500 ms
10=3000 ms
11=3500 ms
12=4000 ms
13=4500 ms
14=5000 ms
15=5500 ms
8=170 ms
9=180 ms
10=190 ms
11= 200 ms
12=210 ms
13=220 ms
14=230 ms
15=240 ms
DBS-2.3/9.2-540