Table of Contents
Advertisement
Quick-Start Programming
Node Route Selection (NRS) Assignments
(If not using NRS, skip steps 24 to 29)
24. Enable Least Cost Routing (LCR) for the system.
Address
Options
Note
25. Enable forced NRS/LCR for each extension to use forced NRS/LCR.
Address
Options
Note
26. Enable NRS.
Address
Options
Note
27. Assign the dialed digits that receive NRS processing.
Address
Options
DBS-2.3/9.2-540
FF1 2# 1# 3# (0/1)#
0=Disable LCR
1=Enable LCR
This parameter enables LCR.
LCR must be enabled for NRS to operate.
FF3 (1-144)# 4# (0/1)#
0=Disable forced NRS/LCR
1=Enable forced NRS/LCR
This parameter requires the user to dial "9" to dial out of the
system.
FF1 8# 4# 8# 1# 16# (0/1)#
0=Disable NRS
1=Enable NRS
LCR must be enabled (step 24 above) for NRS to operate.
When the system finds an exact match of these digits, NRS processing is
triggered. (See Table 2-35 on page 30 and following tables.)
FF1 8# 4# 8# 2# (1-50)# 1# (XXXXXX)#
1-50=The NRS Entry Number. Up to 50 NRS entries are
available for each system
XXXXXX=The dialed digits that must be matched to use
NRS. Up to 6 digits may be entered. All trailing digit posi-
tions not entered are assumed null. For instance, if 4 digits
are entered, the 2 possible remaining trailing digits posi-
tions are disregarded. Any digits entered require an exact
match. (Default = null (******)
T1 Networking - Revised April 2000
Programming Initial T1 Network Options
Page 75
Advertisement
Table of Contents
