Panasonic DBS Section 540 Reference Manual page 70

Programming Initial T1 Network Options
10. Specify the outgoing signaling type used by the T1.
Address
Options
Note:
11. Specify the incoming signaling type used by the T1.
Address
Options
Note:
12. Make certain that the inbound ring pattern is set to a value other than 0.
Address
Options
Note:
Page 70
Any trunks used for T-1 Networking require wink start.
FF1 8# 4# 6# (1-64)# 3# (0-2)#
0=Immediate start
1=Wink start
2=Dial-tone start
Select only Wink Start for network trunks.
Note: The above command requires a system restart to take effect.
Any trunks used for T-1 Networking require wink start.
FF1 8# 4# 6# (1-64)# 4# (0-1)#
0=Immediate start/ringdown
1=Wink start
Select only Wink Start for network trunks.
Note: The above command requires a system restart to take effect.
Network trunks must supply their own ringing pattern.
FF2 (1-64)# 17# (0-9)#
0=Synchronize (ring pattern determined by CO)
1=3 sec. on/1 sec. off
2=2 sec. on/2 sec. off
3=1 sec. on/1 sec. off
4=1 sec. on/2 sec. off
5=1 sec. on/3 sec. off
6=.5 sec. on/.5 sec. off
7=.5 sec. on/.5 sec. off/.5 sec. on/2.5 sec. off.
8=.5 sec. on/3.5 sec. off
9=1 sec. on/7 sec. off
Do not select 0 for a network trunk.
T1 Networking - Revised April 2000
Quick-Start Programming
DBS-2.3/9.2-540