Windows System Requirements - Epson Stylus Pro 4000 Printer Manual

12 | Introduction
Caution: Using an
improperly shielded
cable—especially a
cable more than 10 feet
long—may cause the
printer to malfunction.
For USB connection: a compliant USB port and a shielded USB "AB"
•
cable from Series A (computer) to Series B (printer), up to 10 feet
long
For IEEE 1394 (FireWire
to 10 feet long
For network connection: the optional Ethernet card (described on
page 10) and a compatible cable

Windows System Requirements

To use your printer in either a stand-alone or peer-to-peer network
environment, your system should include the requirements listed below:
®
IBM -compatible PC with a Pentium
•
recommended
For USB connection: PC with USB port running Windows
•
(factory installed), Me, 2000, or XP
For IEEE 1394 connection: PC with FireWire port running
Windows Me, 2000, or XP
For 10/100 Base TX Ethernet connection: Ethernet equipped PC
running Windows 98, Me, NT 4.0, 2000, or XP
At least 512MB of RAM
•
At least 100MB of free hard disk space to install the software, and at
•
least 2GB of free hard disk space for processing files (8GB or more
available hard disk space recommended)
Quad-speed (4×) CD-ROM or DVD drive for installing the printer
•
software
For USB connection: a Windows-compliant USB port and a shielded
•
USB "AB" cable from Series A (computer) to Series B (printer), up to
10 feet long
For IEEE 1394 (FireWire) connection: the optional IEEE 1394 port
(described on page 10) and a shielded IEEE 1394 cable up to 10 feet
long
For network connection: the optional Ethernet interface card (described
on page 10) and a compatible cable
® ) connection: a shielded IEEE 1394 cable up
®
12
IV 1 GHz or higher processor
® 98 SE