Epson Stylus Pro 4000 Printer Manual page 41

7. Examine the printed pattern for the most evenly overlapping lines. In
the example shown above, the lines under number 4 are the most even.
8. After printing the pattern,
button to select the number noted in step 7.
9. Press the
Menu
The menu options shown below appear in sequence. Make any
adjustments, as needed, and press the
setting.
You can also make similar settings using the printer driver software. For
instructions, see page 50 (Mac OS X), page 66 (Mac OS 9), or page 83
(Windows).
• CUT METHOD
thinner media, or adjust the speed for thick media. You may need to
experiment to determine the cleanest cut for your paper.
• PPR FEED ADJUSTMENT
lower value if you see white lines on your prints, or a higher value if
you see dark lines.
• EJECT ROLLER TYPE
with non-EPSON media. You may need to experiment to
determine the best setting for your paper.
• DRYING TIME
smearing the ink. You can make the print head wait up to 5 seconds
after each pass to allow ink to dry on the page.
lets you decrease the paper suction level when printing
• SUCTION
on thinner media (less than 12 lb), such as CAD drafting paper or
backlight film.
adjusts the intensity of the MicroWeave
• M/W ADJ
improves print quality, but lowers printing speed.
10. When done, press the
1-41
Handling Paper and Other Media
THICKNESS NUM
button to save the selected value.
Menu
lets you decrease the cutting blade pressure for
helps eliminate banding. Choose a
lets you define the eject roller for printing
lets you print with non-EPSON media and avoid
Pause button.
|
is displayed. Press the
button to save each
®
pattern. This
41