Checking The Broom Cable; Checking The Broom Shaft Shear Pin - Toro 38700 Service Manual

Checking the Broom Cable

SERVICE INTERVAL
After the first 2 hours, Yearly.
1. Turn off the engine, wait for all moving parts to stop,
and remove the spark plug wire(s).
2. Remove the belt cover and engine shield.
3. With the broom lever disengaged, ensure the gap
between the broom clutch assembly and the tab is
1/8" (3.2 mm). If the broom is not properly adjusted,
see "Adjusting the Broom Drive" (page 2-11).
B
A
A. Broom Clutch Assembly
B. Tab
C. 1/8" (3.2 mm)
Walk-Behind Rotary Broom Service Manual
SPECIFICATIONS & MAINTENANCE
C
Fig. 007
Checking the Broom Shaft
Shear Pin
SERVICE INTERVAL
Before each use or daily.
1. Move the machine to a level surface.
2. Turn off the engine, wait for all moving parts to stop,
and remove the spark plug wire(s).
3. Check the shear pin located on the broom shaft on
either side of the gear box.
A. Nut
B. Shear Pin
4. If the shear pin is damaged, remove the pin and
replace with a Toro recommended pin. Secure the
pin with a nut.
A
B
Fig. 008
2-9