Toro 38700 Service Manual page 51

TRACTION DRIVE SYSTEM
3. Remove the 32-tooth sprocket gear and the thrust
washer from the shaft.
4. Remove the shift collar and flat washer from
the shaft.
NOTE
Shift collars are marked right and left hand at the top of
the inside flange.
5. Unbolt the four guide collars from the shaft.
5-18
6. Remove the wheel clutch components from the other
end of the shaft.
Fig. 068
7. Remove the three (per gear) compression springs
from under the pawls and set aside.
Fig. 069
8. Remove the six (per side) T-27 Torx screws that hold
the pawl supports.
Fig. 070
Walk-Behind Rotary Broom Service Manual
Fig. 071
Fig. 072
Fig. 073