9. Install the compression springs under the pawls.
10. Slide the thrust washer onto the 32-tooth
sprocket gear.
11. Slide the complete 32-tooth gear sprocket onto
the shaft.
Walk-Behind Rotary Broom Service Manual
TRACTION DRIVE SYSTEM
12. Install the flat washer.
13. Make sure the 11-tooth gear slides on so it is flush
with the end of the shaft.
Fig. 084
14. Make sure the pawls are up against the thrust
washer and the springs are not binding and are
compressing properly.
Fig. 085
Fig. 086
Fig. 087
Fig. 088
5-21