11. The 44-tooth gears should have the hub facing
inward.
12. Slide one end of the axle shaft with tube into
the housing.
Walk-Behind Rotary Broom Service Manual
TRACTION DRIVE SYSTEM
13. With the woodruff key out of the other side of the
shaft as well as all other components, install the axle
bearing onto the housing and then slide the shaft in
through the bearing and housing, through the two
washers, and 44-tooth gear into the tube.
Fig. 045
14. Insert the woodruff key onto the axle shaft evenly.
Make sure the 44-tooth gear can ride over the
shaft freely.
Fig. 046
Fig. 047
Fig. 048
5-13