TRACTION DRIVE SYSTEM
3. Clamp or hold the gear and turn it over to properly
install the three pawl supports and Torx screws.
4. Torque the T-27 Torx screws to 100 - 125 in - lbs
(11.3-14.1 Nm).
5. Install the four guide collars to the shaft with the shift
brace plate.
6. Torque the screws to no more than 50-70 in - lbs
(5.65-7.9 Nm).
5-20
7. Slide the flat washers next to the guides.
Fig. 079
8. Install the RIGHT and LEFT collar.
NOTE
The top flanges of the shift collars have "right" and "left"
stamped into them. Install accordingly on the right and
left ends of the shaft with the shift brace plate oriented
as shown.
Fig. 080
Walk-Behind Rotary Broom Service Manual
Fig. 081
Fig. 082
Fig. 083