Toro 38700 Service Manual page 52

9. Remove the retainer plate off the gear hub.
10. Remove the pawl pins and pawls from the
32-tooth gear.
11. Repair or replace components as needed.
Walk-Behind Rotary Broom Service Manual
TRACTION DRIVE SYSTEM
Wheel Clutch Assembly
NOTE
Apply a light coat of SAE 30W oil to the intermediate
shaft before assembly.
1. Set the 32-tooth gear on a flat surface and install the
pawls. Apply a light coat of oil to the dowel pins and
install the dowel pins into the pawl assembly.
Fig. 074
2. With the pawls facing up and away from the hub,
slide the retainer plate onto the hub. Make sure the
pins are seated flush and the retainer plate sits flush
onto the gear.
Fig. 075
Fig. 076
Fig. 077
Fig. 078
5-19