Traction Cable Adjustment; Clutch Cable Replacement Removal - Toro 38700 Service Manual

CONTROLS

Traction Cable Adjustment

1. The traction lever should be in the full upright
position with some slack in the traction cable to
begin adjustment.
2. Adjust using the turnbuckle (A). Hold the cable to
prevent twisting.
3. Locate the traction rod on the left side just below the
belt cover. Adjust the cable turnbuckle until there is
a slight gap between the end of the rod and the front
of the slot maximum 1/16" (1.5 mm). Secure the jam
nut on the turnbuckle.
3-6
A
Fig. 010
Fig. 011
Clutch Cable Replacement
Removal
1. To replace the clutch cables, drain the fuel tank
remove broom and stand the machine forward onto
the hood. Remove both lower covers. The wheels
and the bottom cover can also be removed
if desired.
2. Remove the nut and washer that attach the cable
clamp to the handle.
3. Slip the cable Z-bend out of the wheel clutch lever
on the handle.
Walk-Behind Rotary Broom Service Manual
Fig. 012
Fig. 013