Installing The Cutting Units (For Cutting Unit Models 04610 And 04611 Only); Gauge Bar; Bolt (#10 X 5/8 Inch); Jam Nut (#10) - Toro 04357 Operator's Manual

Battery terminals or metal tools could short
against metal tractor components causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery, do
not allow the battery terminals to touch any
metal parts of the tractor.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
tractor.
Figure 10
1. Negative (-)
3. Connect the black ground cable (from the engine
base) to the negative (-) post of the battery. Secure it
with a wrench and coat the terminal with petroleum
jelly.
Incorrect battery cable routing could damage
the tractor and cables causing sparks. Sparks
can cause the battery gasses to explode,
resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative (black)
cable.
4. Install the battery clamp and washers and secure
them with the wing nuts.
5. Place the terminal cover over the positive (+) battery
post.
2. Positive (+)
4
Installing the Cutting Units
(For Cutting Unit Models 04610
and 04611 Only)
Parts needed for this procedure:
1

Gauge bar

1

Bolt (#10 x 5/8 inch)

1

Jam nut (#10)

3

Cutting unit

6

Washer

6

Ball stud

3

Grass basket

Procedure
Note: When sharpening, setting the height-of-cut
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
support tubes on the front of the frame to prevent
damage to the hoses.
1. Remove the cutting units from the cartons. Assemble
and adjust them as listed in the cutting unit Operator's
Manual. Use the gauge bar from the loose parts kit
to adjust the height of cut.
2. Mount a washer and ball stud to each end of the
front roller on the cutting units (Figure 11).
1. Pull frame
2. Pull arm
3. Slide the cutting unit under the pull frame while
hooking the lift hook onto the lift arm (Figure 12).
14
Figure 11
3. Ball stud