Lubrication; Greasing The Machine - Toro 04357 Operator's Manual

Lubrication

Greasing the Machine

Lubricate the grease fittings regularly with No. 2 General
Purpose Lithium-Base Grease. If the you operate the
machine under normal conditions, lubricate all bearings
and bushings after every 50 hours of operation.
Locate the grease fitting as follows:
• Rear wheel roller clutches and external ball bearing
(1) (Figure 38)
Figure 38
• Steering fork shaft (1) (Figure 39)
• Rod end (Figure 39)
Figure 39
• Lift arm pivot (3) and pivot hinge (3) (Figure 40)
• Pull frame shaft and roller (12) (Figure 41)
• Power steering cylinder (Figure 42)
• Lift cylinders (3) (Figure 43)
32
Figure 40
Figure 41
Figure 42