Specifications; Attachments/Accessories; Operation; Think Safety First - Toro 04357 Operator's Manual

Reel Speed Control
Use the reel speed control (Figure 23) to adjust the RPM
of the reel.

Specifications

Note: Specifications and design are subject to change
without notice.
Overall Width w/reels
Overall Length
Overall Height
Overall Weight with Reels
Net Weight (dry)
Width of Cut
Wheel Tread
Wheel Base
Mow Speed (adjustable)
Transport Speed
Reverse Speed
Reel Speed

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
69–3/4 inches (177 cm)
90 inches (228.6 cm)
48-1/2 inches (123.2 cm)
1256 lb (570 kg)
969 lb (440 kg)
59 inches (149.9 cm)
49-1/2 inches (125.7 cm)
46-7/8 inches (119.1 cm)
2–5 MPH approximately
(3.2–8 km/h)
8.8 MPH approximately
(14.1 km/h)
2.5 MPH (4 km/h)
1975 RPM approximately

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions
and symbols in the safety section. Knowing this
information could help you or bystanders avoid injury.
The use of protective equipment, such as but not
limited to, for eyes, ears, feet, and head is recommended.
This machine produces sound levels in excess
of 85dBA at the operator's ear and can cause
hearing loss through extended periods of
exposure.
Wear hearing protection when operating this
machine.

Checking the Engine Oil

The engine is shipped with 1-3/4 quarts (1.65 liters)
(w/filter) of oil in the crankcase; however, the oil level
must be checked before and after the engine is first
started.
The engine uses any high-quality detergent oil having
the American Petroleum Institute (API) service
classification of SG, SH, or SJ or higher. The
recommended viscosity (weight) is SAE 30.
1. Position the machine on a level surface.
2. Unscrew the dipstick and wipe it with a clean rag.
Screw the dipstick into the tube and make sure it is
seated fully (Figure 24).
1. Dipstick
19
Figure 24
2. Filler cap