Ignition Switch - Toro 04357 Operator's Manual

to mow (not to neutral) while the machine is in motion.
No damage will result.
• Rear Position-neutral and backlapping
• Middle Position-used for mowing operation
• Front Position-used for transport operation

Ignition Switch

Insert the key into the switch (Figure 19) and turn it
clockwise as far as possible to the Start position to start
the engine. Release the key as soon as the engine starts;
the key will move to the On position. Turn the key
counterclockwise to the Off position to stop the engine.
Steering Wheel Locking Lever
Rotate the lever (Figure 20) forward to loosen the
adjustment, raise or lower steering wheel for operator
comfort, then, rotate the lever rearward to tighten the
adjustment.
1. Steering wheel locking lever
Steering Arm Locking Knob
Loosen knob (Figure 21) until shoulder on knob clears
the notches in steering arm. Raise or lower steering arm
to desired height while aligning shoulder of knob with
notch in steering arm. Tighten knob to lock adjustment.
Figure 20
1. Steering arm locking knob
Fuel Shut-Off Valve
Close the fuel shut-off valve (Figure 22), under the fuel
tank, when storing or transporting the machine on a
truck or trailer.
1. Fuel shut-off (under the fuel tank)
Backlap Lever
Use the backlap lever (Figure 23) in conjunction with the
lower mow/raise control lever for backlapping the reels.
1. Backlap lever
18
Figure 21
Figure 22
Figure 23
2. Reel speed control