Changing The Engine Oil - Toro 74311TE Operator's Manual

Changing the Engine Oil

Service Interval: Every 100 hours (more often in dirty or
dusty conditions).
Note: Dispose of the used oil at a recycling center.
1. Park the machine so that the rear is slightly lower than
the front to ensure that the oil drains completely.
2. Move the speed control lever to the N
to stop the machine.
3. Disengage the PTO, engage the parking brake, shut off
the engine, and wait for all moving parts to stop.
1
3
5
Figure 40
position
EUTRAL
2
4
G025156
4. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the full mark on the dipstick
5. Start the engine and drive to a flat area. Check the oil
level again (Figure
6. If needed, add oil to the Full mark on the dipstick.
Changing the Engine-Oil Filter
Service Interval: Every 200 hours
Note: Change the engine oil filter more frequently when
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to
Engine Oil (page
2. Change the engine oil filter
Note: Allow 2 minutes for the new oil to be absorbed
by the new filter material.
36
(Figure
39).
Changing the
36).
(Figure 41).
39).