Shutting Off The Engine - Toro 74311TE Operator's Manual

With 122cm direct-collect cutting unit
Hide thumbs Also See for 74311TE:
Table of Contents

Advertisement

Figure 15
6. Turn the ignition key to the S
12). When the engine starts, release the key.
Important: Do not crank the engine continuously
for more than 10 seconds at a time. If the engine
does not start, wait 60 seconds between starting
attempts. Failure to follow these guidelines can
burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
7. If the choke is in the
return choke to the
OPEN
warms up.
g025065
position
(Figure
TART
/
position, gradually
CLOSED
ON
/
position as the engine
OFF

Shutting Off the Engine

CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Important: Set the parking brake before transporting.
1. Disengage the PTO.
2. Move speed control lever to the N
3. Engage the parking brake.
4. Place the throttle to the middle position.
5. Allow the engine to run for a minimum of 15 seconds,
then turn the ignition switch to the O
shut off the engine.
6. Remove the key to prevent children or other
unauthorized persons from starting the engine.
7. Close the fuel shut-off valve when you do not use the
machine for a few days, when transporting, or when
you park the machine inside a building.
5
20
position.
EUTRAL
position to
FF
4
15 Sec
g025066
Figure 16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z master 8000 series

Table of Contents