Adjusting The Locking-Pin Stop On The Mower Deck; Cleaning; Cleaning Under The Mower; Cleaning Debris From The Machine - Toro 74311TE Operator's Manual

Adjusting the Locking-Pin
Stop on the Mower Deck
1. Slide the mower deck-locking pins in on both sides and
rotate to lock the deck in the operating position.
2. Loosen the jam nut and turn the stop screw clockwise
until the locking pin is tight and cannot be rotated by
hand (Figure 79).
Figure 79
1. Rotate the stop screw clockwise until locking pin is tight,
then back off 1/2 turn.
2. Loosen the jam nut
3. Loosen the stop screw counter clockwise 1/2 turn and
tighten the jam nut.
4. Test the locking pin to make sure that it slides freely.
Adjust it if necessary.

Cleaning

Cleaning under the Mower

Service Interval: Before each use or daily
1. Move the speed-control lever to the N
to shut off the machine.
2. Disengage the PTO, engage the parking brake, stop the
engine, and wait for all moving parts to stop.
3. Lift the mower deck and secure in the raised position.
Refer to Raising the Mower Deck into Service Position
(page 22).
4. Clean any grass build-up under the mower deck.
5. Lower the mower deck to the operating position.
Refer to Lowering the Mower Deck to the Operating
Position (page 23).
Cleaning Debris from the
Machine
Service Interval: Before each use or daily
1. Shut off the engine, wait for all moving parts to stop,
and remove the key. Engage the parking brake.
2. Clean off any oil, debris, or grass buildup on the
machine, especially around the fuel tank, around the
engine and exhaust area.

Disposing of Waste

Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
57
position
EUTRAL