Special Tools - Toro Greensmaster 3150 Service Manual

Special Tools

OTC (Owatonna Tool Company) supplies special tools
for servicing Toro Commercial Products. The TORO
SPECIAL TOOLS AND APPLICATIONS GUIDE shows
service tool applications.
Gauge Bar Assembly
Used to verify height–of–cut.
Toro Model Number: 13–8199
Backlapping Brush Assembly
Used to apply lapping compound to cutting units while
keeping the operator's hands at a safe distance from the
rotating reel.
Toro Model Number: TOR299100
Bedknife Screw Tool
This screwdriver–type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar.
IMPORTANT: DO NOT use and air or manual impact
wrench with this tool so damage to the bedbar will
be prevented.
Toro Model Number: TOR510880
Roller Bearing Installation Tools
Washers and spacer used to install bearings and seals
into front and rear rollers that have a threaded roller
shaft.
Seal installation washer (black): # 107–8133
Seal installation spacer: # 107–3505
Bearing installation washer (yellow): # 104–6126
Greensmaster 3150
Some tools may have been supplied with your mower or
available as TORO parts. Some tools may also be avail-
able from a local supplier.
Seal Installation
Washer
Page 10 - 3 Rev. A
Figure 2
Figure 3
Figure 4
Bearing Installation
Seal Installation
Washer
Spacer
Figure 5
Dual Point Adjust Cutting Units