Toro Greensmaster 3150 Service Manual page 260

6. Apply grease to drive pulley splines and pulley hub
taking care not to get grease on belt surface. Slide drive
pulley onto the reel shaft.
7. Apply anti–seize lubricant to threads of flange head
screw (item 4) used to attach drive pulley to reel shaft.
Secure drive pulley to reel with washer (item 5) and
flange head screw.
8. Place square key (item 31) in groomer shaft slot and
install driven pulley onto the groomer shaft. Thread
flange nut (item 17) onto the shaft threads.
9. Secure groomer reel by holding the flange nut (item
17) on one end of the reel and tightening the flange nut
on the other end of groomer shaft. Torque flange nuts
from 100 to 120 in–lb (11.3 to 13.6 N–m).
10.Apply Loctite #242 (or equivalent) to threads of cap
plug (item 21). Install cap plug into non–drive side plate
and torque cap plug from 60 to 80 ft–lb (81 to 108 N–m)
(Fig. 8).
11. Insert front roller into non–drive side groomer arm.
12.Position drive side groomer arm to front roller,
groomer drive side plate and cutting unit frame. Secure
groomer arm to cutting unit with carriage bolt, tab wash-
er and flange nut.
Groomer (DPA Cutting Unit) (Rev. A)
13.Apply antisieze lubricant to threads of lift arm assem-
bly stud on groomer arm. Install spring washer (item 24)
and lock nut (item 25) to secure drive side groomer arm
assembly to groomer side plate (Fig. 7).
14.Center front roller and tighten cap screws (item 20)
to secure roller (Figs. 7 and 8).
15.Install groomer drive belt and belt cover to side of cut-
ting unit (see Groomer Belt Replacement in this sec-
tion).
16.Install hydraulic reel motor onto cutting unit (see Hy-
draulic Reel Motor Installation in the Service and Re-
pairs section of Chapter 10 – DPA Cutting Units).
17.If equipped, install rotating rear roller brush to cutting
unit.
18.Lubricate groomer bearings (see Groomer Reel Kit
Installation Instructions).
Note: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe excess
grease from groomer shaft and seals.
19.Check groomer reel height and mower height–of–cut
settings. Adjust as needed.
Page 10.1 – 10 Greensmaster 3150