Adjustments; Adjustments; Height/Depth Of Groomer Adjustment - Toro Greensmaster 3150 Service Manual

Adjustments

CAUTION
Never work on the cutting unit with the engine
running. Always stop the engine and remove the
key from the ignition switch before working on
the mower.
Note: See Cutting Unit Operator's Manual for adjust-
ment procedures for the cutting units on the Green-
smaster 3150.

Height/Depth of Groomer Adjustment

Note: Grooming is performed above the soil level.
When adjusting groomer height/depth, groomer blades
should never penetrate the soil.
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Make sure rollers are clean and cutting reel is set to
the desired height–of–cut (See Cutting Unit Operator's
Manual for cutting unit adjustment procedures).
3. Position the groomer reel to the lowered, grooming
position (Fig. 3).
Note: Improper or over–aggressive use of the groom-
er reel (i.e. too deep or too frequent grooming) may
cause unnecessary stress on the turf leading to severe
greens damage. Use the groomer cautiously.
4. On one end of the groomer reel, measure the dis-
tance from the lowest tip of the groomer blade to the
working surface. Lift and turn height adjustment knob to
raise or lower the blade tip (Fig. 3). Each notch on the
adjustment knob changes the groomer height approxi-
mately 0.003 inch (0.08 mm).
5. Repeat step 4 on the opposite end of the groomer.
Then, recheck setting on the first side of groomer.
Height setting on both ends of groomer should be identi-
cal.
Groomer (DPA Cutting Unit) (Rev. A)
1. Height adjustment knob
Page 10.1 – 6
1
Figure 3
2. Lock screw (lowered)
Greensmaster 3150
2