Service And Repairs; Service And Repairs; Groomer Belt Replacement - Toro Greensmaster 3150 Service Manual

Service and Repairs

Groomer Belt Replacement

1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. If equipped, remove rotating rear roller brush from
cutting unit.
3. Remove two (2) lock nuts that secure groomer belt
cover, then remove cover (Fig. 4).
4. Pivot idler pulley by placing a 12mm wrench on
pulley nut and rotating idler bracket to relax belt tension.
Slip groomer drive belt off pulleys (Fig. 5). Carefully re-
lease idler bracket.
5. Install new drive belt to drive pulley, idler pulley and
driven pulley observing correct belt routing (Fig. 5).
6. Secure belt cover to housing with two (2) lock nuts
(Fig. 4).
7. If equipped, install rotating rear roller brush to cutting
unit.
Greensmaster 3150
1. Groomer belt cover
2. Lock nut
4
1. Drive pulley
2. Idler pulley
3. Idler pulley nut
Page 10.1 – 7 Groomer (DPA Cutting Unit) (Rev. A)
1
2
Figure 4
3. Cap
2
3
5
Figure 5
4. Driven pulley
5. Groomer drive belt
2
3
1