Toro Greensmaster 3150 Service Manual page 259

7. Remove lock nut (item 35), tab washer (item 34) and
plow bolt (item 27) that secure drive side groomer arm
assembly to drive side plate. Do not change height–of–
cut screw adjustment. Remove drive side groomer arm
assembly from cutting unit.
8. Remove front roller assembly from cutting unit.
Note: To prevent groomer shaft from turning when re-
moving driven pulley, use wrench on shaft flats to hold
shaft.
9. Remove the flange nut (item 17) that secures driven
pulley (item 32) to groomer shaft. Remove driven pulley
from shaft. Locate and retrieve square key (item 31) that
locates pulley on shaft.
Note: To prevent cutting reel from turning when re-
moving drive pulley, block reel with piece of wood.
10.Remove flange head screw (item 4) and washer
(item 5) that secure drive pulley (item 7) to the cutting
reel shaft. Slide drive pulley from cutting reel.
11. Remove two shoulder nuts (item 8) that secure the
groomer drive side plate (item 10) to the cutting unit
frame. Remove the groomer drive side plate assembly.
12.Remove the cap plug (item 21) from non–drive side
plate (Fig. 8).
13.Remove the flange nut that secures the groomer
shaft to the non–drive side plate.
14.Pull the groomer reel from the non–drive side plate.
15.Inspect seals, bushings and bearings in side plates
for wear or damage. Replace components as needed.
Installation
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Apply a light coating of grease to seal lips in RH and
LH side plates. Make sure that seals, bushings and
bearings are properly positioned in side plates.
3. Carefully place groomer reel assembly into the non–
drive side plate bearings taking care not to damage seal
in side plate. Thread flange nut (item 17) onto the shaft
threads but do not tighten.
4. Make sure that groomer shim (item 11) is installed on
groomer drive side of cutting unit.
5. Carefully place drive side plate onto groomer shaft
taking care not to damage seals in side plate. Position
side plate to the cutting unit frame and secure with two
shoulder nuts (item 8).
Greensmaster 3150
3
1. Cap screw
2. Front roller shaft
2
1. Roller retaining cap screw
2. Cap plug
3
1. Drive side plate
2. Drive pulley
Page 10.1 – 9 Groomer (DPA Cutting Unit) (Rev. A)
4
2
Figure 7
3. Groomer shaft assembly
4. Locknut/spring washer
Figure 8
1
Figure 9
3. Driven pulley
1
1
2