Figure 38: Managed Ap Status - D-Link DWC-1000 User Manual

Wireless Controller

Figure 38: Managed AP status

MAC Address: The Ethernet address of the controller-managed AP.
IP Address:
Age:
Status
• Discovered: The AP is discovered and by the controller, but is not yet
authenticated.
• Authenticated: The AP has been validated and authenticated (if authentication
is enabled), but it is not configured.
• Managed: The AP profile configuration has been applied to the AP and it's
operating in managed mode.
Failed: The Controller lost contact with the AP, a failed entry will remain in the
managed AP database unless you remove it. Note that a managed AP will
temporarily show a failed status during a reset.
Profile: The AP profile configuration currently applied to the managed AP. The
profile is assigned to the AP in the valid AP database.
Radio Interface: Shows the wireless radio mode that each radio on the AP is
using.
This page includes the following buttons:
• Delete—Manually clear existing APs
The network IP address of the managed AP.
Time since last communication between the Controller and the AP.
The current managed state of the AP. The possible values are:
67
User Manual