Iec61850 Edition 1 / Edition 2 Mapping - ABB rec670 Commissioning Manual

Section 1
Introduction
1.5
16
• the character ^ in front of an input/output signal name indicates that the
signal name may be customized using the PCM600 software.
• the character * after an input signal name indicates that the signal must be
connected to another function block in the application configuration to
achieve a valid application configuration.
• Logic diagrams describe the signal logic inside the function block and are
bordered by dashed lines.
• Signals in frames with a shaded area on their right hand side represent
setting parameter signals that are only settable via the PST or LHMI.
• If an internal signal path cannot be drawn with a continuous line, the suffix
-int is added to the signal name to indicate where the signal starts and
continues.
• Signal paths that extend beyond the logic diagram and continue in another
diagram have the suffix "-cont."

IEC61850 edition 1 / edition 2 mapping

Table 1: IEC61850 edition 1 / edition 2 mapping
Function block name
AEGPVOC
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BCZSPDIF
BCZTPDIF
BDCGAPC
BRCPTOC
BRPTOC
BTIGAPC
BUSPTRC_B1
BUSPTRC_B2
BUSPTRC_B3
BUSPTRC_B4
BUSPTRC_B5
BUSPTRC_B6
BUSPTRC_B7
Table continues on next page
Edition 1 logical nodes
AEGGAPC
AGSAL
SECLLN0
ALMCALH
BCZSPDIF
BCZTPDIF
SWSGGIO
BRCPTOC
BRPTOC
B16IFCVI
BUSPTRC
BBSPLLN0
BUSPTRC
BUSPTRC
BUSPTRC
BUSPTRC
BUSPTRC
BUSPTRC
1MRK 511 360-UEN A
Edition 2 logical nodes
AEGPVOC
AGSAL
ALMCALH
ALTIM
ALTMS
ALTRK
BCZSPDIF
BCZTPDIF
BBCSWI
BDCGAPC
BRCPTOC
BRPTOC
BTIGAPC
BUSPTRC
BUSPTRC
BUSPTRC
BUSPTRC
BUSPTRC
BUSPTRC
BUSPTRC
Bay control REC670 2.1 IEC
Commissioning manual