Checking The Binary I/O Circuits; Binary Input Circuits; Binary Output Circuits; Checking Optical Connections - ABB rec670 Commissioning Manual

1MRK 511 360-UEN A
4.10
4.10.1
4.10.2
4.11
Bay control REC670 2.1 IEC
Commissioning manual
Verify that the contact sockets have been crimped correctly and that
they are fully inserted by tugging on the wires. Never do this with
current circuits in service.
Current circuit
1. Verify that the contacts are of current circuit type.
2. Verify that the short circuit jumpers are located in the correct slots.
Voltage circuit
1. Verify that the contacts are of voltage circuit type.
2. Check that no short circuit jumpers are located in the slots dedicated for voltage.
Trip and alarm circuits
1. Check that the correct types of contacts are used.

Checking the binary I/O circuits

Do not insert anything else to the female connector but the
corresponding male connector. Inserting anything else (such as a
measurement probe) may damage the female connector and prevent a
proper electrical contact between the printed circuit board and the
external wiring connected to the screw terminal block.

Binary input circuits

Preferably, disconnect the binary input connector from the binary input cards. Check
all connected signals so that both input level and polarity are in accordance with the
IED specifications.

Binary output circuits

Preferably, disconnect the binary output connector from the binary output cards.
Check all connected signals so that both load and polarity are in accordance with IED
specifications.

Checking optical connections

Check that the Tx and Rx optical connections are correct.
Section 4
Starting up
51