Setδcause_Table; Setδcc_Convert; Setδcdn_Pattern - NEC MG-SIP Configuration Manual

Note: Assign this data in accordance with the specifications of connected SIP network.
7.5.3.5 SETΔCAUSE_TABLE
The command is used to select the translation table of error cause to be sent to LAN received from SIP network as
error response. Pressing the Enter key can skip the item. In this case, default values are assigned automatically. To
make this assignment effective, it is required to execute the "REBOOT" command to restart the MG-SIP16.
Note: Assign this data in accordance with the specifications of connected SIP network.
7.5.3.6 SETΔCC_CONVERT
This command is used to assign calling party's country code display conversion feature (since version
09.00.00.00). Pressing the Enter key can skip the item. To make this assignment effective, it is required to execute
the "REBOOT" command to restart the MG-SIP16.
When this feature is available, conversion will take place as in the following table.
It is possible to confirm the previous settings through this command since this command is an extention of
the previous version's SETΔ81to0.
Note: Assign this data in accordance with the specifications of connected SIP network.
7.5.3.7 SETΔCDN_PATTERN
The command is used to assign the way of obtaining information for called number from SIP network.
When isub parameter is enabled, the called number is obtained from isub of URI-PARAM within Request-
URI. If the called number cannot be obtained from isub, it will be obtained from TO header or Request-
URI that has been set in Config.
Pressing the Enter key can skip the item. In this case, default values are assigned automatically. To make this
assignment effective, it is required to execute the "REBOOT" command to restart the MG-SIP16.
MG-SIP Page 29 of 75 5/8/2009