Setδhc_Alarm; Setδhc_Timer; Setδinterface; Setδipaddress - NEC MG-SIP Configuration Manual

7.5.3.17 SETΔHC_ALARM
This command is used to specify a type of health check alarm. When health check timeout occurs or when 30
seconds have passed before health check timeout, Health Check Alarm function is activated to send warning tone
using this settings. To make this assignment effective, it is required to execute the "REBOOT" command to restart
the MG-SIP16.
7.5.3.18 SETΔHC_TIMER
This command is used to specify the health check time-out. Pressing the Enter key can skip the item. In this case,
default values are assigned automatically. To make this assignment effective, it is required to execute the "REBOOT"
command to restart the MG-SIP16.
7.5.3.19 SETΔINTERFACE
This command is used to assign the Ether speed and the duplex type to each port on MG-SIP16. Pressing the Enter
key can skip the item. In this case, default values are assigned automatically. To make this assignment effective, it is
required to execute the "REBOOT" command to restart the MG-SIP16.
Note: When "Automatic Negotiation" is selected, "Full Duplex" is automatically applied to the interface.
Therefore, this command line will not appear for interface that is specified as "Automatic Negotiation". When
100M is specified for Ether 1, the duplex type should also be assigned for Ether 1.
7.5.3.20 SETΔIPADDRESS
This command is used to assign an IP Address and a subnet mask to each Ether port on MG-SIP16. Pressing the
Enter key can skip the item. In this case, default values are assigned automatically. To make this assignment
effective, it is required to execute the "REBOOT" command to restart the MG-SIP16.
• Ether1: LAN (IPX network) side
• Ether2: WAN (SIP network) side
MG-SIP Page 36 of 75 5/8/2009