Setδsignaling_Port_Number; Setδsip_Port_No; Setδsip_Qos; Setδsip_Register - NEC MG-SIP Configuration Manual

•
When Session-Timer is Disable (=1) is selected:
7.5.3.35 SETΔSIGNALING_PORT_NUMBER
This command is used to specify the UDP port number that receives the control signal packets. Pressing the Enter
key can skip the item. In this case, default values are assigned automatically. To make this assignment effective, it is
required to execute the "REBOOT" command to restart the MG-SIP16.
7.5.3.36 SETΔSIP_PORT_NO
The command is used to specify a port number that receives SIP messages. Pressing the Enter key can skip the item.
In this case, default values are assigned automatically. To make this assignment effective, it is required to execute
the "REBOOT" command to restart the MG-SIP16.
7.5.3.37 SETΔSIP_QOS
This command is used to specify the QoS of Session Initiation Protocol (SIP). Pressing the Enter key can skip the
item. In this case, default values are assigned automatically. To make this assignment effective, it is required to
execute the "REBOOT" command to restart the MG-SIP16.
7.5.3.38 SETΔSIP_REGISTER
The command is used to assign an IP address or a Fully Qualified Domain Name (FQDN) to the SIP registrar. This
command is required for using a Proxy Server. Pressing the Enter key can skip the item. In this case, default values
are assigned automatically. To make this assignment effective, it is required to execute the "REBOOT" command to
restart the MG-SIP16.
MG-SIP Page 47 of 75 5/8/2009