Installation Checklist And Start-Up; Checklist - ABB ACS800 Hardware Manual

60

Installation Checklist and Start-Up

Checklist

Check the mechanical and electrical installation of the drive before start-up. Go
through the checklist below together with another person. Read the "Safety
Instructions" on the first pages of this manual before you work on the unit.
Check
MECHANICAL INSTALLATION
The ambient operating conditions are allowed. See "Mechanical Installation", Technical Data: NEMA Ratings,
Ambient Conditions.
The unit is fixed properly on floor and a vertical non-flammable wall. See "Mechanical Installation".
The cooling air will flow freely.
ELECTRICAL INSTALLATION See "Planning the Electrical Installation", "Electrical Installation".
The motor and the driven equipment are ready for start. See Planning the Electrical Installation: Motor Selection
and Compatibility, Technical Data: Motor Connection.
The +E202 EMC filter capacitors are disconnected if the drive is connected to an IT (ungrounded) system.
The capacitors are reformed if stored over one year, refer to ACS 600/800 Capacitor Reforming Guide
[64059629 (English)].
The drive is grounded properly.
The mains (input power) voltage matches the drive nominal input voltage.
The mains (input power) connections at L1, L2 and L3 and their tightening torques are OK.
Appropriate mains (input power) fuses and disconnector are installed.
The motor connections at U2, V2 and W2 and their tightening torques are OK.
The motor cable is routed away from other cables.
Voltage setting of the brake resistor fan transformer (if present).
There are no power factor compensation capacitors in the motor cable.
The external control connections inside the drive are OK.
There are no tools, foreign objects or dust from drilling inside the drive.
Mains (input power) voltage cannot be applied to the output of the drive (with bypass connection).
Drive, motor connection box and other covers are in place.
Installation Checklist and Start-Up