Siemens SINUMERIK 810D Commissioning Manual page 68

Installing software and network operation
3.3 Network operation with the Service desktop
Note
The "MPI driver" package available on the PCU is part of the HMI software and must not be
uninstalled!
Installation under Windows XP
You must follow the installation sequence described here!
1. Booting up the PCU in the service desktop.
2. Access CD 1 (via network or external CD-ROM drive) call up SETUP.EXE in the root
3. The installation proceeds with operator prompting. The installation directory for STEP 7
4. The prompt for "Transfer license keys" must be answered with "No, transfer the license
5. Switch to the SINUMERIK_Add_on directory on CD 2 and call up SETUP.EXE there. The
6. Start the link "STEP7 authorizing" on the service desktop. This authorizes STEP 7 and
3-20
directory there.
should be changed to F:\... where directory in F: can be freely selected.
keys later." The licensing is done after the installation of SINUMERIK AddOn. Once
installation is complete, the PC will need to be rebooted. During boot up, select the
service desktop again.
installation proceeds with operator prompting. Once installation is complete, the PC will
need to be rebooted. During boot up, select the service desktop again.
starting can now be done from the HMI Advanced operator interface (STEP 7 appears as
its own operating area on the expansion bar of the area menu, protected with protection
level 3).
The following entries are made automatically in F:\Add_on\oemframe.ini:
[s7tgtopx]
; with HMI Advanced: eliminate minimize/maximize buttons
; of the Step7 window
WindowStyle_Off=196608
; with HMI Advanced: switch to previous task when Step7 is
terminated
nSwitchToTaskAfterTermination= -2
These entries may also need to be modified in OEM configurations.
Commissioning Manual, 10/2006, 6FC5397-0DP10-0BA0
PCU Basesoftware (IM6)