Panasonic AAD03011 Instruction Manual page 26

Depending on the start mode function setting, if "the fault trip is reset" or
"the stop state is released with the panel STOP function" or "door width
measurement is reset" when the run signal is input, the inverter may restart
suddenly.
(Secure personal safety before using this function.)
Failure to do so could lead to injury.
When the retry function is used, the inverter may automatically start (restart).
Keep out of the working part of the motor and the machine.
(Secure personal safety before using this function.)
Failure to so could lead to injury.
Note
!
The heat sink fins and brake resistor can reach high temperatures, so do
not touch them.
Doing so could lead to burns.
The inverter can be easily set to run from low speeds to high speeds.
Confirm the tolerable range of the motor and machine before starting operation.
Failure to do so could lead to injure.
Prepare holding brakes if required.
Failure to do so could lead to injure.
If there is no arrival signal, start operation before ensuring the security and
function operation of the lift system.
(Secure personal safety before starting operation.)
Failure to do so could lead to injury.
When carrying out the door repeat control and the door width measurement,
the operation direction of the door may change automatically. Start operation
after ensuring personal safety.
Failure to do so could lead to injury.
Adjust and confirm each parameter before operating. Depending on the
settings of the parameters, the inverter may work unexpectedly.
Failure to do so could lead to injure.
Before turning power ON, check the following points again.
Check that all wiring is correct.
Reversed wiring between the power supply and the load, in particular,
can result in damage to the inverter.
Make sure the inverter rating and power supply voltages match each other.
Make sure no power factor capacitor is connected to the motor, as it can
damage the inverter and the capacitor.
Before starting a trial run, check the set frequency.
24