Stop Mode (Parameter P10); Stop Frequency (Parameter P11); Dc Brake Time And Dc Brake Level (Parameter P12 And P13); Max. Output Frequency And Base Frequency (Parameter P14 And P15) - Panasonic AAD03011 Instruction Manual

STOP MODE(Parameter P10)
Used to select whether to ramp-to-stop or coast-to-stop when stopping the inverter.
Data
setting value
ramp-to-stop
0
1 coast-to-stop
STOP FREQUENCY(Parameter P11)
Used to set the frequency which the inverter output stops when the inverter
decelerate to a stop.
Data setting range (Hz)
DC BRAKE TIME and DC BRAKE LEVEL(Parameter P12 and P13)
The DC brake can be applied when the inverter output frequency drops below
the stop frequency during ramp-to-stop or when switching between forward run
and reverse run.
[Parameter P12: The DC brake time is set.]
Data setting range(s)
[Parameter P13: The DC brake level is set.]
Data setting range
[ramp-to-stop]
Stop
frequency
(P 1 1)
DC brake time(P12)
MAX. OUTPUT FREQUENCY and BASE FREQUENCY
(Parameter P14 and P15)
Used to set the maximum output frequency
and base frequency.
(These parameters are valid only when
"FF" is set in Parameter P03.)
[Parameter P14: The max. output frequency is set.]
Data setting range (Hz)
[Parameter P15: The base frequency is set.]
Data setting range (Hz)
46
Details
The frequency is decelerated by the stop signal according
to the deceleration time, and then the motor stops.
The inverter output is shut off immediately by the stop
signal.
0.5 to 60 (Set in 0.1Hz increments)
000 0.1 to 120 (The brakes are not applied when 000 is set.)
0 to 100 (Set in increments of 5. The braking force will increase
when a larger value is set.)
[Forward run / reverse run]
0.5Hz
50.0 250
45.0 250
Explanation of operation
The frequency for applying the
DC brake is set by parameter
P11 stop frequency.
The DC brake time when
switching between forward run
and reverse run is fixed to 0.1s.
DC brake time
fixed to 0.1s
100
Output frequency (Hz)
Max. output frequency
(P14)
Base frequency (P15)
0