Manual Transmission - Sanyo SFX-110 Instruction Manual

Manual transmission
Manual transmission is like placing a call and then sending a fax. When your call is answered
by a fax tone, the SFX-I 10/21 O automatically starts fax transmission.
Using the speakerphone or handset, you can monitor the line activity.
1. Place the original document face down.
Adjust the paper guide to the width of
STD
NORMAL
the document.
2. Select a contrasthesolution mode if
necessary. (See page 30.)
[
STD
NORMAL
3. Lift the handset (or press speaker key)
4. Dial the number.
Exampie:l 11-2222
1
1112222 *
You can also use one of the following dialing methods: .
One-touch dialing
Press a one-touch key (1 - 8). Programming is required in advance. See pages 64-65.
Speed dialing
Press [SPEED DIAL] and enter the speed dial number (01 -20). Programming is required in
advance. See pages 66-67.
Dial Bank dialing
Press [DIAL BANK] to select a number from the 20 most frequently dialed number list
stored in Dial Bank. Then press [START1. See pages 26-27.
Direct dialing
Dial the number using the number keys.
5. When the SFX-1 10/21 O detects a fax tone sent by the
receiving unit, transmission begins automatically.
Al ison McNab
The name/number of the receiving party appears
on your display if their fax machine has a station ID
programmed.
6. Replace the handset.
If a person answers your fax call at step 5, you can send a fax by pressing [STARTl after the
conversation.
Press [STOP] to interrupt a transmission or to remove a document set for transmission.
If you make a mistake when entering a number, replace the handset and lift it again
(or press speaker key twice), then enter the correct number.
The feature switch No. 54 must be set to the ON (01) position for auto progress transmission
to take place at step 5. (This feature is factory-set to ON) See page 80.
If it is set to the OFF (00) position, the [START'j key has to be pressed to initiate transmission.
31