Connecting To The Unit; Configuring The Management Pc - Motorola PTP 250 User Manual

PTP 250 User Guide

Connecting to the unit

Perform this task to connect a management PC to the unit, power it up and open the web
interface.
This task consists of the following procedures:
•

Configuring the management PC

•
Connecting to the PC and powering up
•
Logging into the web interface
Configuring the management PC
Install Java on the management PC (if not already installed), as this is used by the PTP 250
web interface.
To configure the local management PC to communicate with the PTP 250, proceed as
follows:
1
Select Properties for the Ethernet port.
2
Select the Internet Protocol (TCP/IP) item as shown in
3
Click on Properties.
4
Enter an IP address that is valid for the 169.254.X.X network, avoiding:
169.254.0.0 and 169.254.1.1 and 169.254.1.2
A good example is 169.254.1.3
5
Enter a subnet mask of 255.255.0.0.
Leave the default gateway blank.
phn-2182_003v004 (Oct 2011)
on page 6-3
on page 6-5
on page 6-6
(Figure 6-2).
UNDER DEVELOPMENT
Connecting to the unit
Figure 6-1.
6-3