Using the installation wizard
Step 2: Wireless configuration
Step 2 of the Installation wizard is for updating the wireless configuration
The attributes are described in
Next.
To comply with FCC rules, unselect any channels that may interfere with TDWR radars.
This must be done before the units are allowed to radiate on site. The system designer will
have provided a list of any affected channels, based on the instructions in
weather radars (USA only)
When operating with external antennas in countries that impose an EIRP limit, choose an
external antenna and RF cable that will not cause the PTP 250 to exceed the EIRP limit,
based on the instructions in
page 2-13.
Figure 6-15 Step 2: Wireless Configuration page
6-16
Table 6-2.
on page 2-5.
Calculating maximum power level for connectorized units
UNDER DEVELOPMENT
Chapter 6: Configuration and alignment
Update the attributes as required and select
phn-2182_003v004 (Oct 2011)
(Figure
6-15).
Avoidance of
on