Motorola APX 1000 Basic Service Manual page 172

3-8 Basic Theory of Operation: Controller Section
The ARM controller core of the OMAP processor handles the power up sequence of all devices,
including firmware upgrades, and all operating system tasks that are associated with FLASH and
SDRAM memories and user interface communication. The FLASH memory (64 MB) is required to
store the firmware, tuning, and Codeplug settings, which upon initialization get read and stored into
SDRAM (32MB) for execution. The ARM and DSP core jointly control and configure audio, wireless
and RF devices linked to the Serial Peripheral Interface (SPI) and Synchronous Serial Interface
(SSI) buses to enable radio FM and optional wireless communication protocols.
The power and most clocks to the controller devices are provided by the MAKO IC and external
switching and linear regulators on board. A Complex Programmable Logic Array (CPLD) IC divides
the 24.576 MHz clock from MAKO to source OMAP's 32 kHz Real Time Clock. OMAP's main clock is
supplied externally from an on board 12 MHz crystal.
The radio has two internal microphones and an internal speaker, as well as available microphone
and speaker connections for external accessories. The internal 4 Ohm speaker is located on the
same side as the main display and keypad of the radio. The internal speaker is driven by a Class D
audio amplifier located on the main board that is capable of delivering a rated power of 0.5 W. The
external accessory speaker is driven by a Class AB audio amplifier on the MAKO IC that is capable
of delivering 0.5 W of power into a 16 Ohm as a minimum load. Both speaker paths use the CODEC
for volume control and to convert the audio signal from digital to analog. Both internal and external
microphones use the CODEC's ADC to deliver digital audio samples to the DSP controller.
The user interface block consists of a main display, a keypad, top controls and the accessory side
connector. The side connector (Universal Connector) provides audio, USB, RS232 communication
for accessories. All signals to and from the connector go through the internal keypad board before
reaching the microcontroller and other devices on the main board.