Transfer Island Contour - Cycle75 - Siemens SINUMERIK 840D Programming Manual

Milling Cycles
3
3.15 Pocket milling with islands - CYCLE73, CYCLE74, CYCLE75

3.15.2 Transfer island contour - CYCLE75

Pocket milling with islands is an option and requires
SW 5.2 in both the NCK and MMC 103.
Programming
CYCLE75 (_KNAME, _LSANF, _LSEND)
Parameters
_KNAME
string
_LSANF
string
_LSEND
string
Function
Cycle CYCLE75 transfers island contours to the pocket
milling cycle CYCLE73. The cycle is called once for
each island contour. It need not be called if no island
contours are programmed.
The transferred parameter values are written to the
temporary file opened by CYCLE74.
Description of parameters
The number and meaning of parameters are the
same as for CYCLE74.
(see CYCLE74)
3-184
Name of contour subroutine of island contour
Block number/label identifying start of contour definition
Block number/label identifying end of contour definition
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
03.96
08.99
3
 Siemens AG 2000 All rights reserved.