Configuring Help Displays - Siemens SINUMERIK 840D Programming Manual

12.97
1

1.4.4 Configuring help displays

Explanation
Help displays for MMC100
If you wish to modify the standard graphics or create
additional graphics, you will need to have a graphic
program on your PC. The maximum size of the
graphic is limited to 272 x 280 pixels. It is
recommended that you make all graphics the same
size.
The MMC uses the PCX format of Zsoft Paintbrush
as graphic format. If you do not have a graphic
program that can create this format, you can use the
Paint Shop Pro program to convert your graphics.
The Paint Shop Pro application is not included
on the diskette supplied by Siemens.
Help displays for MMC 102/103
The help displays of the MMC 102/103 are located in
the file system under the directory
DH\DP.DIR\HLP.DIR.
You can use the "Copy" function in the Services
menu to read data from a floppy disk. To do this,
select the destination directory via "Interactive
programming" and "DP Help".
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
1.4 Cycle support in program editor (SW 4.3 and later)
Example of cycle parameterization graphics
General
1
1-33