Siemens SINUMERIK 840D Programming Manual page 278

Turning Cycles
4
4.10 Extended stock removal cycle - CYCLE950 (SW 5.3 and later)
N10 $TC_DP1[4,1]=500 $TC_DP2[4,1]=3
$TC_DP6[4,1]=0.4 $TC_DP24[4,1]=80
N15 G18 G0 G90 DIAMON
N20 T3 D1
N25 X300
N30 Z150
N35 G96 S500 M3 F2
N45 CYCLE950("Part1",,,"Machine_Part3",
321111,8,1,1,0.8,0.7,0.6,0.5,1,45,6,
"DEFAULT",,,"Blank3",0,91,0,91,1)
N50 G0 X300
N55 Z150
N60 T4 D1
N65 G96 S500 M3 F2
N75
CYCLE950("Part1",,,"Finish_Part3",311311,
0.5,0.25,0.25,0.8,0.7,0.6,0.5,1,45,6,"Bla
nk3",,,,,,,,1)
N160 M2
Finished part contour:
as for sample program 1
4-278
Tool for roughing
Tool for roughing residual material and
finishing
X
Finished-part contour
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
03.96
04.00
4
Updated blank contour after
first machining step
 Siemens AG 2000 All rights reserved.
Z