ABB AC500 Introduction Manual page 132

The following information is given for the selected modules: Slot number (Slot), module type (Module)
and definition of the input bytes/words IB/IW and the output bytes/words QB/QW. Then we have to
specify the expansion modules of the used hardware. In our example this is a digital input/output module
DC532 and an analog input/output module AX522 .
After you have added all required modules into the configuration list, click on OK to apply the
configuration.
Call the address table before you specify the parameter data (via View -> Address Table ) in order to
update the addresses of the input/output variables.
If you want to change the device parameters of the slave, select the device entry to highlight it by a
rectangle. Press the right mouse button and select Parameter Data from the context menu.
____________________________________________________________________________________________________________
G1
Introduction to AC500 1-130
AC500 / Issued: 07.2006