Setting Of The Slave Address Of The Fbp Plug Onto The Ac500 Cpu; Configuration On The Cpu - ABB AC500 Introduction Manual

Setting of the Slave Address of the FBP plug onto the AC500 CPU (if needed, but
not recommended)
Normally the FBP slave address is set using the AC500 Control Builder. Neverthless it is possible to set
this address using the CPU.
The FieldBusPlug must have a properly assigned slave module address. The AC500 CPU gives them an
address at system power-up. The address can be set with the use of the display and the pushbutton on
the top of the module.
Attention: The local setting of an FBP address by means of pushbuttons and display has a
higher priority than an FBP address configured by the AC500 Control Builder!
The locally set address replaces the address configured by the software.
It is highly recommended to be extremely careful when modifying the address locally, because it has
high influence on the behaviour of the application.
Up to 99 addresses can be then set with the display.
By using the CFG , the ar-
row keys and the OK
pusbutton, some parame-
ters of the CPU can be
configured.
CFG
OK
Figure: Configuration on the CPU
____________________________________________________________________________________________________________
G1
Introduction to AC500
SYS
BATT
I/O-Bus
PWR RUN
RUN
VAL
WARNING!
Use of
incorrect
ESC
battery may
cause fire or
OK
explosion.
1-50
PM581
ETH
FBP
COM1
COM2
ERR
DIAG
CFG
INSERT
MC
PUSH
502
CPU
24 V DC 10 W
AC500 / Issued: 07.2006