Air Cooler Intake Hose Installation - Yamaha WaveRunner FX SHO Service Manual

POWR
Air cooler, supercharger, and throttle body assembly
1
2
LT
242
1
c
a
2
1
2
b
1
c
5-40
2. Install:
• Supercharger
Installation step:
1. Tighten the supercharger bolts 1, and
then bolts 2 to the specified torque.
Supercharger bolt (M8 × 65 mm) 1:
20 N·m (2.0 kgf·m, 14.8 ft·lb)
LOCTITE 242
Supercharger bolt (M6 × 65 mm) 2:
10 N·m (1.0 kgf·m, 7.4 ft·lb)
LOCTITE 242

Air cooler intake hose installation

1. Install:
• Air cooler intake hose 1
Installation steps:
1. Install the air cooler intake hose 1
between the supercharger and air cooler.
NOTE:
• Make sure that the arrow mark a on the air
cooler intake hose 1 is pointing up.
• Make sure that the hose 1 contacts the pro-
jection b on the air cooler.
2. Tighten each clamp 2 to the specified
torque.
NOTE:
Fit each hose clamp 2 over the white paint
mark c on each end of the air cooler intake
hose 1, making sure that the fastener of the
clamp is aligned with the wide portion of the
paint mark as shown.
Air cooler intake hose clamp:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
E
1
2
3
4
5
6
7
8
9